7/8” AR SRMW25G26-EZ Pressure Washer Pump

The AR SRMW25G26-EZ is one of the more popular AR power washer pumps used for replacement on a wide range of commercial pressure washer brands including:

• Briggs & Stratton, Brute, BSPP Elite
• Clean Shot, Companion, Craftsman
• Delta, DeWalt, Diamond
• Husqvarna, John Deere, Murray
• Porter Cable, Sears, Troy-Bilt and more

AR EZ start pumps have specially designed valves allowing for easy engine startup. This Annovi Reverberi SRMW25G26-EZ vertical shaft pump unit fits most 7/8-inch shaft engines. It delivers 2.5GPM and 2600 PSI @ 3400 RPM. It includes a built-in chemical injector, thermal relief valve and pressure control.

THIS PUMP IS NO LONGER AVAILABLE. IT HAS BEEN REPLACED WITH THE SRMW24G28-EZ YOU CAN ORDER FROM THIS PAGE BUT WILL RECEIVE THE OTHER PUMP


AR (ANNOVI REVERBERI) 7/8" VERTICAL SHAFT PRESSURE WASHER PUMP WITH EZ START VALVES

2.5 GPM | 2600 PSI | 3400 RPM | GAS ENGINE FLANGE

BUILT-IN PRESSURE CONTROL & CHEMICAL INJECTOR

PHYSICAL SIZE: CLICK “TECHNICAL SPECS” TAB ABOVE

INPUT: FEMALE GARDEN HOSE | OUTPUT: 22MM/14MM MALE (ACCEPTS FEMALE SCREW CONNECT)

CONVENIENT CONNECTION TO MOST 7/8" SHAFT ENGINES

PUMP IS PREFILLED WITH OIL | THERMAL RELIEF VALVE IS INCLUDED

EZ START VALVES ALLOW FOR EASY ENGINE STARTING

FITS MANY RESIDENTIAL MACHINES SEE “EXTENDED INFORMATION”

TO CONFIRM THIS IS THE CORRECT PUMP FOR YOUR MACHINE: CLICK HERE

COVERED BY AR ONE YEAR WARRANTY FOR DETAILS CLICK: AR WARRANTY

AVAILABILITY: IN STOCK

THERE IS AN “SX” VERSION OF THIS PUMP WHICH IS USED ON A NUMBER OF MACHINES WITH THE WATER CONNECTIONS AT THE REAR.THE PORTS ON THE “SX” VERSION ARE ROTATED 180 DEGREES FROM THE STANDARD.

NOT ALL “SX” PUMPS ARE MARKED AS SUCH SO YOU SHOULD TAKE A LOOK AT THE PICTURE BELOW BEFORE ORDERING TO DETERMINE WHICH PUMP YOU NEED. “SX” IS THE SUFFIX IN THE PRODUCT CODE.SRMW2.2G26-EZ-SX

THIS PUMP IS COMMONLY FOUND ON RESIDENTIAL USE PRESSURE WASHERS.  THESE MACHINES ARE MADE BY SEVERAL MANUFACTURES UNDER NUMEROUS BRAND NAMES.  A PARTIAL LIST OF THE BRAND NAMES IS BELOW.  THIS PUMP WILL FIT MANY OF THOSE UNITS.  THIS PUMP IS MOST OFTEN USED ON MACHINES WHERE THE WATER CONNECTIONS ARE AT THE FRONT OF THE MACHINE.  CALL OR EMAIL US IF YOU ARE NOT SURE THIS IS THE PUMP YOU NEED.

THIS AXIAL RADIAL  PUMP WILL PUMP UP TO 2.2 GPM AT 2600 PSI. IT SPINS AT 3400 RPM IN A DIRECT DRIVE SYSTEM COUPLED WITH A GASOLINE ENGINE. THE MATCHING FLANGE PROVIDES CONVENIENT CONNECTION TO MOST 7/8” SHAFT ENGINES. THE HOLLOW SHAFTED PUMP INCLUDES A BUILT-IN PRESSURE CONTROL VALVE, AND CHEMICAL INJECTION SYSTEM.

BRIGGS, BRIGGS & STRATTON, BRUTE, BSPP ELITE, CLEAN SHOT, COMPANION, CRAFTSMAN, DELTA, DEVILBISS, DEWALT, DIAMOND,  DR, EXCELL, GENERAC, HUSKY, HUSQVARNA, JOB BOSS, JOHN DEERE, MAXUS, MURRAY, PORTER CABLE, POWER BOSS, SEARS, SIMPLICITY, SPEED CLEAN,  TASK FORCE, TROY-BILT, VOX, WATER BLASTER

Use only AR64545 oil for the AR RM, XJ, SJ and BK Series pumps only: Do NOT change oil. Use oil only to add if low. This oil is a specially formulated synthetic with special additives for the demands of the RM, XJ, SJ and BK pump series. No other oil is factory approved for these pumps, and could result in pump failure.