SPECIAL ORDER NOT RETURNABLE OTHER THAN FOR DEFECT EXCHANGE
GIANT 24 MM BELT DRIVE PRESSURE WASHER PUMP
LEFT HAND DRIVE
1450 RPM | 4.1 GPM | 3300 PSI
1750 RPM | 5.0 GPM | 2700 PSI
INPUT: 1/2" FPT | OUTPUT: 3/8" FPT
AVAILABILITY: SPECIAL ORDER
Flow 2.5 GPM, Maximum Discharge Pressure 2500 PSI, Maximum Inlet Pressure Up to 90 PSIG,
Pump Speed 3450 RPM, Plunger Diameter 4.23”, Stroke 5.1mm (7.1o angle), Crankcase Oil Capacity (Horizontal) 4.1 fl.oz. Crankcase Oil Capacity (Vertical) 4.7 fl. oz. Temperature of Pumped Fluids Up to 80 F, Inlet Port 1/2" NPT, Discharge Port........3/8" NPT, Shaft Rotation Either Direction, Weight 9 lbs, Width 8.325", Height.... 6.45", Swash Plate Bore (Horizontal).3/4" x 3/16" Keyway, Swash Plate Bore (Vertical) 7/8" x 3/16" Keyway,
Valve Type Polyamide Plastic
A 25 PSIG minimum inlet pressure is required.
The pump itself can be driven in either direction of rotation; however, the cooling fan
on TEFC motors must always be positioned so that the cooling air is drawn from the
non-drive end of the motor towards the pump.
HORSEPOWER RATINGS: The rating shown are the power requirements for the pump. Gas
engine power outputs must be approximately twice the pump power requirements shown above.
We recommend a 1.15 service factor be specified when selecting an electric motor as the power source. To compute specific pump horsepower requirements, use the Following formula:
Electric HP = (GPM X PSI) / 1460 Gasoline HP = (GPM X PSI) / 1100
GX2525 ELECTRIC HORSEPOWER
REQUIREMENTS
RPM GPM 1000 PSI 1500 PSI 2000 PSI 2500 PSI
3450 2.5 1.7 2.6 3.4 4.3
GX2525 GAS HORSEPOWER
REQUIREMENTS
RPM GPM 1000 PSI 1500 PSI 2000 PSI 2500 PSI
3450 2.5 2.3 3.4 4.5 5.7
NOTE: MOST HORIZONTAL SHAFT PUMPS HAVE A 3/4” SHAFT THIS ONE IS 7/8”
THIS PUMP IS FOUND ON SOME EXCELL, DEVILBISS, PORTER CABLE AND OTHER BRANDS OF MACHINES. CALL OR EMAIL US IF YOU ARE NOT SURE THIS IS THE PUMP YOU NEED.
|
